To remove BELLAMI Clip in Hair Extensions, snap open all the clips and gently lift up and away from your hair. Insert and position the 4 side pieces so they frame the face and blend with your own hair. If there are any gaps, correct this by snapping the clip open, lifting it off hair and repositioning it so that the weft lies flat. Now that the BELLAMI Clip in Hair Extensions are attached, run your fingers along the weft to make sure it lies flat against your head along the entire width. Repeat the process with a new parting above each weft extension. Now insert the remaining wefts in the same manner as above. STEP 7 – PLACEMENT OF THE REMAINING WEFTS Each time secure the extra hair, on top of your head. To do this, comb down a layer of hair, with about half an inch or so between each weft layer. Release the hair you held out of the way and create a new parting. Snap the clip shut, so it grips your hair. Die Beschreibung der Kunstwerke wurde mit grter Sorgfalt vorgenommen. Insert the snap clip on your hair not on the raw scalp. Maangaben in Klammern ( ) beziehen sich auf die Blattgre. Next take one of the wider hair wefts and insert the opened centre clip just below the parting. Then open all the clips so they are ready to be inserted into your hair. The first weft should be long enough, so that the weft is wide enough to sit along the back of your hairline. Take the first weft from your pack of BELLAMI Clip in Hair Extensions. Starting at the lowest point on the hairline, and using a tail comb or your index fingers, create a part where you wish to section off the hair.Ĭlip your remaining hair, firmly on the top of your head, to keep it out of the way as you fit the wefts. *Also, you can start parting even lower, as low as you want to place the first weft*īELLAMI Clip in Hair Extensions should be attached from the bottom up. Starting at the lower back section of your head, use a tail comb or index finger to divide (horizontally part) your hair, at the lower back of the head i.e.

Klammer zuerst